Pin'd Performance!

*Consistently bringing stock in - call if you do not see your fitment!

EMX ASCENDER

TOE TO HEEL, THE BEST BOARD FOR YOUR FEET (AND WALLET)

EVERYTHING STARTS WITH STANCE. WHEN YOUR FEET ARE SOLID, YOUR RIDING IS SOLID.

Precision Milled - Made from billet aluminum, these running board inserts upgrade your riding experience with minimal cutting compared to other styles of aftermarket boards.

Traction Geometry - Chances are, your boots were expensive. The Pin'd EMX exclusive traction pattern won't cut your boots up, but rather they hold your boots, while allowing snow and ice to evacuate. The tractions studs "squeeze" into the voids of your boots tread pattern vs slicing into them like sharp points or screws do.

No Round Edges - Round is slippery and fatiguing. EMX boards are flat. No bird feet feeling and a consistent flat surface to land every time you do "that one move."

Retain Stock Structure - Keep your sled's structural integrity. You only need to cut out the inner contour of the EMX board from the stock boards and transfer drill the rivets holes.

NEW FEATURES:

Suspension/Chassis Integration - Ties into the rear suspension hanger (Stainless Steel Rivets included) increasing strength and rigidity.

Fit and Finish - A complete front to rear fit and finish, matching stock angles and aesthetics.

No Question Positioning - Use the 4 rear holes to line up the boards, clamp and get to drilling/cutting. Yes, there is still wiggle room for those with a few miles on your sled.

COLORS - We've done our best to match Artic Cat's colors. Below is a list of what we offer and the match rating.

All necessary hardware and instructions are included to install! Instructions can be found just below as well!

Instructions